Hello folk,
I configured jumbo frame on my 5,5 U3 to connect with a DotHill NAS. I set the same MTU on my NAS and network switches too.
Just I have a doubt.
I read this document:
https://kb.vmware.com/s/article/1007654
It says that one has to change the MTU of the virtual switch, but it says nothing about the associated VMkernel port.
So now I have the vswitch with the Jumbo MTU (9000), but the ISCSI vmkernel port has a normal 1500 MTU.
Is it correct?
Any suggestion, link, doc etc.etc. will be very appreciated.
Have a nice day
d